Results 1 to 1 of 1

Thread: Burner cuts out when blower starts

  1. #1
    Join Date
    Jan 2017

    Default Burner cuts out when blower starts

    I have an Armstrong ultra SX 80, Model #GUJ100D14, approx. 20 yrs. old. I have just replaced the control board, (bad relay) in the unit. The original ST9120A2004 board has been obsoleted by Honeywell and replaced with the ST9120U1011, which I installed. I also cleaned out the unit, flame sensor, filters and changed the pressure switch that was sticking. The problem I have now is this. The furnace goes through the ignition sequence and the burner lights normally. After about 2 minutes, the burner shuts off and the blower turns on. After about 2-3 more minutes, the blower stops and the whole sequence repeats itself. I have attached pictures of the 2 boards. Any help would be greatly appreciated!
    Attached Thumbnails Attached Thumbnails Burner cuts out when blower starts-20170117_104747-jpg   Burner cuts out when blower starts-20170120_171250-jpg   Burner cuts out when blower starts-20170120_171302-jpg  
    Last edited by BT2112; 01-21-2017 at 06:10 PM.

Similar Threads

  1. Blower Capacitor
    By BDT45 in forum Heating & Air conditioning
    Replies: 3
    Last Post: 09-19-2018, 07:10 AM
  2. dual burner switch
    By Boman in forum Appliance Repair
    Replies: 10
    Last Post: 12-01-2016, 10:04 PM
  3. Stove Burner Won't Light - Appliance tip of the week...
    By jeff1 in forum Appliance Tip of the Week
    Replies: 0
    Last Post: 06-09-2016, 10:09 PM
  4. Replies: 1
    Last Post: 11-01-2014, 09:20 PM
  5. gas burner valve for ge profile model #jgp962bec1bb
    By jeff shearer in forum Appliance Repair
    Replies: 4
    Last Post: 02-09-2013, 10:15 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts