Help spread the word / share us on your favorite social media networks

Facebook Twitter StumbleUpon Reddit LinkedIn

Warm clutch and damp clothes

Warm clutch and damp clothes

Results 1 to 6 of 6

Thread: Warm clutch and damp clothes

  1. #1
    Join Date
    May 2013
    Posts
    1,481

    Default Warm clutch and damp clothes

    Kenmore
    Model : 110.22422100
    Serial : cl3735909
    The complaint is clothes not spinning dry enough with a large load. The drive block looks good. I changed the coupler. Loaded the washer up with what I call a large load (5 pairs of jeans, 3 or4 shirts, pair of short pants, and a pj bottom. At the end of the cycle, the clutch and brake felt somewhat warm to the touch. Not hot enough to sizzle water, but pretty warm.

    The clothes felt pretty good for an older washer, maybe feel a little damper than I like to see them. They are not ringing wet.

    If there is no slippage, should the clutch and/or brake be heating up any?

    There also seems to be a jerking sound coming from the washer.
    I will attempt to post a link to the video.

    https://www.youtube.com/watch?v=Y5Qs1F7cTZE
    Last edited by Boman; 10-07-2014 at 04:16 PM.

  2. #2
    Join Date
    Feb 2012
    Location
    Canada
    Posts
    2,359

    Default

    The clothes felt pretty good for an older washer, maybe feel a little damper than I like to see them. They are not ringing wet.
    If you can't ring any water out of a towel or such, it should have spun fairly good then.

    If there is no slippage, should the clutch and/or brake be heating up any?
    Should slip to slowly get up to speed, should be heating up some yes.

    There also seems to be a jerking sound coming from the washer.
    I will attempt to post a link to the video.
    A slight noise, but didn't appear to be bad at all.

    jeff.
    http://www.applianceaid.com/
    Appliance Repair Aid

  3. #3
    Join Date
    May 2013
    Posts
    1,481

    Default

    Thanks Jeff. I was wondering if it was maybe my imagination and not checking a top load out at the end of spin with clothes in it for a while. I have a front loader in the shop that spins clothes so well I may have been comparing this washer with it.
    I told the lady I had tried a large load in it and I thought a properly working dryer should have no problem drying the clothes.

    Actually, I think there may have been some overloading happening as she is one of those types that has about 20 things going on at any time and always in a rush.

    I might also add, I did change the pump. The one that was on it looked almost new but seemed tighter than necessary. Not sure it made a difference.
    Last edited by Boman; 10-08-2014 at 05:45 AM.

  4. #4
    Join Date
    Feb 2012
    Location
    Canada
    Posts
    2,359

    Default

    The one that was on it looked almost new but seemed tighter than necessary
    Maybe a build up inside?!

    jeff.
    http://www.applianceaid.com/
    Appliance Repair Aid

  5. #5
    Join Date
    May 2013
    Posts
    1,481

    Default

    Nothing visible. The lady has a cleaning service and had a load of raggedy like towels and rags in it when I went to get it. I can imagine these these leaving trace material in the pump shaft where I could not see. It was very stiff to turn. Really too still to turn with my finger. I inserted part of the handle of a pair of channel lock pliers in the hole the motor shaft fits in to turn it. I even pushed on the propeller (?) directly with the plier handle. Still stiff.

    Other than being stiff, it looked very clean

    I hope it is history.

  6. #6
    Join Date
    Feb 2012
    Location
    Canada
    Posts
    2,359

    Default

    Really too stiff to turn with my finger. I inserted part of the handle of a pair of channel lock pliers in the hole the motor shaft fits in to turn it. I even pushed on the propeller (?) directly with the plier handle. Still stiff.
    Good idea to chance it out then!

    jeff.
    http://www.applianceaid.com/
    Appliance Repair Aid

Similar Threads

  1. Trane XB80 seems to work fine except for not blowing warm air
    By admin in forum Heating & Air conditioning
    Replies: 1
    Last Post: 11-25-2015, 12:06 AM
  2. Replies: 3
    Last Post: 09-06-2015, 08:38 PM
  3. Freezer is Cold But fridge section is Warm...
    By jeff1 in forum Appliance Tip of the Week
    Replies: 0
    Last Post: 03-14-2015, 10:50 PM
  4. Noisy Clothes Dryer
    By cpuddin in forum Appliance Repair
    Replies: 3
    Last Post: 03-02-2015, 09:33 PM
  5. Brake/clutch lining dust?
    By Boman in forum Appliance Repair
    Replies: 7
    Last Post: 07-15-2013, 12:56 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •