Activity Stream - EZ Forums

Sort By	Time	Show
Recent Recent Popular Popular	Anytime Anytime Last 24 Hours Last 24 Hours Last 7 Days Last 7 Days Last 30 Days Last 30 Days	All All Photos Photos Forum Forums

Yesterday, 09:11 PM

jeff1 replied to a thread "Clean Lint Filter" in Appliance Repair

Sorry Rick, not 100% sure what you are asking here. jeff.

6 replies | 67 view(s)

Yesterday, 09:08 PM

jeff1 replied to a thread warm freezer in Appliance Repair

Should be open or no continuity at room temp. The L64 is the temp it will cut out at. jeff.

19 replies | 200 view(s)

Yesterday, 03:59 PM

paulmars replied to a thread warm freezer in Appliance Repair

it says 39vte31 40026 L64-41F s17409e 238c2672p004

19 replies | 200 view(s)

Yesterday, 05:16 AM

Boman replied to a thread "Clean Lint Filter" in Appliance Repair

Found it after oosting this. I had seen on there where it explaun the numbers on a GE I think. Dies that explanation go fir all? Is the tech...

6 replies | 67 view(s)

04-23-2018, 11:58 PM

Sonntag posted a visitor message on Sonntag's profile

For a look at your new Jade Ocean Condominium for sale or rent, visit our site now for more details. 17121 Collins Ave

04-23-2018, 10:11 PM

paulmars replied to a thread warm freezer in Appliance Repair

cut thermostat def WR50X10073 out of circuit and heater turns off. Thermostat def WR50X10073 reads 1.8meg ohms at room temperature.

19 replies | 200 view(s)

04-23-2018, 10:02 PM

paulmars replied to a thread warm freezer in Appliance Repair

and causing condensation in the freezer, which then freezes when it gets cold again...ice everywhere more and more as the days pass.

19 replies | 200 view(s)

04-23-2018, 10:01 PM

paulmars replied to a thread warm freezer in Appliance Repair

Did you get a temp reading when that occurred? Above 55°F which is much way too warm for a freezer to be. that heater is on way too long! It's...

19 replies | 200 view(s)

04-23-2018, 09:35 PM

jeff1 replied to a thread "Clean Lint Filter" in Appliance Repair

All dryer cycles should have that yes. Looks like both go back to the board/control. That part works eh!!??!!

6 replies | 67 view(s)

04-23-2018, 09:25 PM

jeff1 replied to a thread warm freezer in Appliance Repair

Defrost thermostat is 64ºF....the heater should remain on until the evaporator temp reaches the approx 64ºF. Did you get a temp reading when...

19 replies | 200 view(s)

04-23-2018, 06:33 PM

Boman replied to a thread "Clean Lint Filter" in Appliance Repair

One of the wires to the door switch had come off. Made sure they were all secure. Seems to have solved the problem. Hope I have them on right....

6 replies | 67 view(s)

04-23-2018, 04:01 PM

paulmars replied to a thread warm freezer in Appliance Repair

removed back plate freezer. watched as it went into defrost. 20 minutes later the heater was still red and it was 55°F in there. Sometime later...

19 replies | 200 view(s)

04-22-2018, 10:46 PM

Boman replied to a thread "Clean Lint Filter" in Appliance Repair

Thanks Jeff. Will do that. Sounds like I need to replace all stats and maybe look for places air might be seeping in.

6 replies | 67 view(s)

04-22-2018, 09:33 PM

jeff1 replied to a thread "Clean Lint Filter" in Appliance Repair

Hi, Dryer repair sheet linked here. Sounds like something may have over heated.

6 replies | 67 view(s)

04-22-2018, 08:43 PM

Boman started a thread "Clean Lint Filter" in Appliance Repair

Frigidaire dryer Model: FEFB9100ES0 Complaint: Ran 3 loads and Clean Lint Filter light came on and quit running. Only the second time I have...

6 replies | 67 view(s)

04-20-2018, 10:39 PM

jeff1 replied to a thread warm freezer in Appliance Repair

The evaporator fan motor in the freezer circulates the air in the freezer and blows the cold air to the fresh food section and also draws the...

19 replies | 200 view(s)

04-20-2018, 05:41 PM

paulmars replied to a thread warm freezer in Appliance Repair

fan in freezer blows cold air and is on most of the time. I took the fan housing off and nothing else there. BTW I unplugged the fridge and 4 hours...

19 replies | 200 view(s)

04-20-2018, 03:58 PM

BB001 replied to a thread Inverter Sub-Panel install in RV (sub-panel size?) in Electrical, Residential

Yes I just thought about that box configuration; found a decent one. I think i will stay with the outdoor box simple to have a convienient cover that...

2 replies | 75 view(s)

04-19-2018, 11:45 PM

suemarkp replied to a thread Inverter Sub-Panel install in RV (sub-panel size?) in Electrical, Residential

As long as the panel is rated for the number of circuits you want, and the twin breaker is listed as a legal type to use in the panel, you could do...

2 replies | 75 view(s)

04-19-2018, 03:18 PM

BB001 started a thread Inverter Sub-Panel install in RV (sub-panel size?) in Electrical, Residential

Hi, I have a 2017 RV with a 50A 240VAC service providing both AC and DC service along with a converter to the RV. I have a Xantrex Freedom XC...

2 replies | 75 view(s)

04-18-2018, 08:48 PM

jeff1 replied to a thread Black stuff under freezer & freezer not cooling properly in Appliance Repair

FZ section is ok :) Is the FF section warm? :( jeff.

5 replies | 93 view(s)

04-17-2018, 11:12 PM

isip replied to a thread Black stuff under freezer & freezer not cooling properly in Appliance Repair

Hey Jeff, Thanks for the follow up, I appreciate you taking the time to provide a thoughtful answer. The freezer seems to be holding its own. The...

5 replies | 93 view(s)

04-15-2018, 09:33 PM

jeff1 started a thread Appliance tip of the week...Oven elements in Appliance Tip of the Week

Appliance tip of the week...Oven elements Always remember Electricity is dangerous and should be treated with respect! Oven Bake and Broil...

0 replies | 126 view(s)

04-15-2018, 01:55 PM

Wanyama replied to a thread Edible garden in Yard and Garden

Growing your own food is not only a great way to save money. It’s also a healthy activity with so many benefits, including the freshest food on the...

1 replies | 1176 view(s)

04-14-2018, 09:35 PM

jeff1 replied to a thread Kenmore controller in Appliance Repair

Yupper...a war of words from China, Mexico and Korea ;) :rolleyes: jeff.

9 replies | 101 view(s)

04-14-2018, 08:31 AM

StaceyBrown posted a visitor message on StaceyBrown's profile

04-14-2018, 06:38 AM

Boman replied to a thread Kenmore controller in Appliance Repair

One think that throws my simple off is the different names for what I assume ti br basically the same piece. Controller on one machine is a relay on...

9 replies | 101 view(s)

04-14-2018, 05:50 AM

angelassasd8951 posted a visitor message on angelassasd8951's profile

Строительство домов Сочи отделка сочи отделка квартир в сочи вип отделка сочи пиво оптом в москве эвакуатор сочи юрист сочи

04-13-2018, 10:36 PM

jeff1 replied to a thread Kenmore controller in Appliance Repair

We all wish there was less! ;) jeff.

9 replies | 101 view(s)

04-13-2018, 05:05 AM

Boman replied to a thread Kenmore controller in Appliance Repair

Went to the bone yard with several others. Eighteen minus some parts. May take about that many today. Too many at one time had my weak mine going...

9 replies | 101 view(s)